Build circuits on a virtual breadboard with real parts and see them work: LEDs that light and burn out, 555 timers, transistors, regulators, logic, a multimeter and warnings. Top view or 3D.
🔒 Your data stays in your browser: nothing you type or upload is sent to a server.
How it works
Pick a part from the list and tap the hole where its first pin goes; power sources go on a rail. Join strips with wires. With the circuit on, it is simulated in time: LEDs light with their real current and burn out when they get too much, capacitors charge, the 555 oscillates, counters and gates switch. Press buttons and switches on the board, move pots and the light on an LDR from the side panel, and read voltages with the multimeter. Warnings tell you when a part is over its rating. The design is saved in your browser and can be shared with a link.
Common questions
How does the simulation work?
Like SPICE, in a simpler form: the breadboard strips and wires become nodes, every part adds its equations, and the circuit is solved every quarter of a millisecond with Newton iterations for diodes and transistors. Capacitors and inductors carry their charge from one step to the next. The 555, gates, the 4017 and the 74HC595 are modelled by their behaviour (thresholds, flip-flops, counters), not transistor by transistor.
How accurate is it?
It is checked against hand calculations: Ohm’s law, dividers, an LED with its resistor, a Zener, a saturated transistor, a MOSFET, a 7805 in and out of regulation, an op-amp with gain 2, an RC charge (63 % at one time constant) and the 555 frequency formula within 12 %. It shows how a circuit behaves; it does not replace a full SPICE simulation for fine design.