LED with resistor on a breadboard
Step-by-step 3D breadboard guide: LED, series resistor computed for your supply and colour, holes, schematic and measurements.
🔒 Your data stays in your browser: nothing you type or upload is sent to a server.
Step-by-step 3D breadboard guide: LED, series resistor computed for your supply and colour, holes, schematic and measurements.
🔒 Your data stays in your browser: nothing you type or upload is sent to a server.
Pick the supply voltage, the LED colour and the current, and the guide computes the series resistor, rounds it up to the next standard value so the current never exceeds your target, and shows exactly which breadboard holes to use. The 3D breadboard and the schematic highlight the same part at every step.
R = (Vs − Vf) / I A slightly larger resistor gives a slightly lower current, which is safe for the LED. A smaller one would exceed the current you chose. The difference in brightness is hardly visible.
Yes. An LED is not a resistance: its current rises very steeply with voltage, so even a small excess can destroy it. Always keep a series resistor.