555 monostable timer on a breadboard

Step-by-step 3D breadboard guide: NE555 one-shot with a trigger button, pulse length T = 1.1 R C, LED and measurements.

🔒 Your data stays in your browser: nothing you type or upload is sent to a server.

How it works

Choose the supply, R1 and C1. The guide gives the pulse length with T = 1.1 · R · C, sizes the LED resistor and shows where the NE555, the trigger button with its pull-up and the timing network go on the breadboard.

Formula

T = 1.1 · R · C

Common questions

Why does the pulse not depend on how long I press?

Pin 2 only has to fall below 1/3 of the supply to start the pulse. The length is then set by C1 charging through R1 up to 2/3 of the supply. Keep the press shorter than the pulse, or the output stays on until you release.

Related tools