XLR 5-pin DMX512 Wiring Guide

DMX512 on 5-pin XLR: data+, data-, shield, optional second link, male and female in 3D

🔒 Your data stays in your browser: nothing you type or upload is sent to a server.

How it works

Follow the steps to solder a 5-pin XLR for DMX512, or switch to the 3-pin to 5-pin adapter table. DMX512-A uses pin 1 for the shield, pin 2 for Data 1−, pin 3 for Data 1+ and pins 4 and 5 for an optional second link. The standard specifies 5-pin XLR; 3-pin is common on fixtures but is not part of it.

Common questions

What is the DMX512 pinout on a 5-pin XLR?

Pin 1 is shield/common, pin 2 is Data 1−, pin 3 is Data 1+, and pins 4 and 5 are Data 2− and Data 2+ for the optional second link, which most equipment does not use.

How do I connect a 3-pin XLR fixture to a 5-pin DMX line?

Use an adapter that wires pin 1 to pin 1, pin 2 to pin 2 and pin 3 to pin 3, leaving pins 4 and 5 unconnected. If the fixture does not respond, check its manual for data polarity.

Can I use a microphone cable for DMX?

It often works on short runs, but it is not recommended. DMX needs a data cable of about 120 Ω, and microphone cable can cause errors and flicker on long chains.

Related tools