XLR Connector Wiring Guide

Pinout and 3D step-by-step assembly for XLR plugs, balanced and unbalanced

🔒 Your data stays in your browser: nothing you type or upload is sent to a server.

How it works

Rotate the 3D XLR plug, pick balanced or unbalanced, and follow the steps to solder each wire to its pin. In the standard convention pin 1 is the shield, pin 2 is hot (+) and pin 3 is cold (−), and both ends of a cable are wired the same way. The pinout highlights the pin you are working on at each step.

Common questions

Which XLR pin is hot?

Pin 2 is hot (+) and pin 3 is cold (−), as in IEC 61938 and AES14. Pin 1 is the shield or ground. Very old equipment sometimes used pin 3 as hot, so check the manual of vintage gear.

How do I wire an XLR for an unbalanced signal?

Connect the core to pin 2 and the braid to pin 1, then join pin 3 to pin 1 inside the connector. This is the usual way to feed an unbalanced source into a balanced input.

Is the male or the female XLR the output?

By the usual audio convention, outputs have male XLR connectors and inputs have female ones. A cable therefore has a female plug for the output side and a male plug for the input side.

Related tools