MIDI DIN-5 Wiring Guide

MIDI DIN 5-pin 180° pinout for cables: current loop, shield, in 3D

🔒 Your data stays in your browser: nothing you type or upload is sent to a server.

How it works

Follow the steps to solder a MIDI cable plug, with pins 2, 4 and 5 highlighted in 3D. In MIDI 1.0 pin 4 is the current source (+5 V through 220 Ω), pin 5 carries the data, pin 2 is the shield, and pins 1 and 3 are not used. The numbers are moulded on the connector, so read them rather than counting positions.

Common questions

What is the pinout of a MIDI DIN-5 cable?

Pin 4 is the current source, pin 5 is the data line and pin 2 is the shield. Pins 1 and 3 are not connected in MIDI 1.0. A standard cable is straight through: 2 to 2, 4 to 4 and 5 to 5.

Is a MIDI cable the same at both ends?

Yes. Both ends are wired identically and either end can go to OUT or IN, because the direction is set by the devices. If pins 4 and 5 are swapped at only one end, the cable does not work.

Can I use a 240° DIN plug for MIDI?

No. MIDI uses the 5-pin DIN with the pins in a 180° arc. The 240° version looks similar but is a different connector and does not fit MIDI sockets.

Related tools