BNC Connector Wiring Guide
Assemble a BNC plug on coax cable: crimp and solder variants, in 3D
🔒 Your data stays in your browser: nothing you type or upload is sent to a server.
Assemble a BNC plug on coax cable: crimp and solder variants, in 3D
🔒 Your data stays in your browser: nothing you type or upload is sent to a server.
Pick crimp or solder, then follow the steps to terminate coax cable, with the centre contact and the braid highlighted in 3D at each step. BNC comes in 75 Ω for video and SDI and 50 Ω for RF and test equipment: the plugs mate, but the mismatch causes reflections at high frequency. The bayonet collar locks with a quarter turn.
They match the impedance of the cable: 75 Ω for video and SDI (RG-59 type cable) and 50 Ω for RF and test equipment (RG-58 type cable). They fit together physically, but mixing them causes reflections at high frequency, which matters most for HD-SDI and above.
Slide the ferrule on, strip the jacket, fold back the braid and cut the dielectric, crimp or solder the centre contact, push it into the body and crimp the ferrule over the braid. Follow the strip lengths in the plug’s data sheet, because they depend on the plug and the cable.
The plug has a rotating collar with two slots, and the jack has two studs. Push the plug on and turn the collar a quarter turn, and the slots catch the studs. Turn it back to release.