PC Case Airflow Planner (3D)

Mount fans and radiators on a 3D case, set how blocked each panel is, pick the graphics card and CPU cooler, and watch the air move

🔒 Your data stays in your browser: nothing you type or upload is sent to a server.

How it works

A generic PC case is drawn in 3D and grows with what you mount: front, top, bottom, rear and side take fans or a radiator. For each panel you set how much of it is solid and whether it has a dust filter; a panel without fans that is not fully closed works as an opening. First the tool finds how much air each fan really moves: every fan follows its fan curve (flow and pressure scale with its speed) and works against the panel, the filter or the radiator in front of it, while the pressure inside the case settles where what comes in equals what goes out, with the surplus leaving or entering through the openings and gaps. Then it solves the air flow on a 3D grid, with the momentum of the fans, the jets they throw and the eddies behind the parts, and the temperature of the air with the heat of the graphics card, the processor, the board and the power supply. The particles move with that solution and take its colour, and the numbers beside it are read from the same solution: the air each part breathes, the average and the hottest spot. The fan and panel figures are typical catalog values, so use it to compare setups and measure your own temperatures.

Formula

fan: p = p_max (rpm/rpm_max)^2 x (1 - Q / Q_max) losses: dp = zeta x rho v^2 / 2 (panel, filter, radiator) openings: Q = A sqrt(2 dp / (rho zeta)) air rise (°C) = heat (W) / (rho cp Q) = 1.76 x W / CFM

Common questions

How much does the front panel matter for PC cooling?

A lot, when it blocks most of the fan. A panel acts like a perforated plate: its pressure loss grows quickly as the open area shrinks, and the fan, which only has a couple of millimetres of water of pressure, slows down to where its curve meets that loss. In this model a mesh front that is 30 percent solid with a filter leaves a 120 mm fan about three quarters of its free-air flow, and a solid front that breathes through side slots (about 60 percent solid) about half. That is why an airflow case runs cooler with the same fans, and why a quiet case is quieter: its fans can turn slower. Static pressure fans lose less behind a dense panel or a radiator.

Positive or negative pressure: which is better?

Positive pressure means the intakes push in more air than the exhausts take out, so the surplus leaves through every gap and opening and the filtered intakes keep the dust out. Negative pressure is the opposite: the exhausts draw air in through the gaps, unfiltered, and dust builds up there. Neither is sealed in a real case, so a small imbalance costs almost no flow; the tool solves the pressure inside (a few pascals at most in an open case), shows how much air comes in unfiltered, and warns when there are so few openings that the pressure starts to slow the fans down. Slightly positive with filtered intakes is the usual recommendation.

Front or top: where does a liquid cooler radiator go?

It is a trade-off between the two big heat sources. Mounted as a front intake, the radiator breathes outside air, which is best for the processor, but it lets in air warmed by the processor’s heat, so the graphics card breathes warmer air. Mounted as a top exhaust, it breathes case air already warmed by the card, so the processor runs a few degrees warmer, while the card gets fresh air. With a hot graphics card the top is usually the better overall choice; the tool shows both temperatures so you can compare your own case.

Related tools