Six petrol engines in 3D, from a 1960s carburetted straight-six to modern turbo engines, driven by a physical model: start them, cut them open, change parts, tune the ECU, run them on a dyno, break them and diagnose faults.
🔒 Your data stays in your browser: nothing you type or upload is sent to a server.
How it works
Pick one of the six engines and one of its versions at the top, press Start and open the throttle with the vertical control (or the arrow keys). Explore lets you cut the engine lengthwise or across, see through it, take it apart and slow it down until you can follow every stroke. Workshop installs parts, changes the fuel and injects faults. Tuning edits the ECU maps or, on the older engines, the distributor and carburettor. Dyno measures torque and power with SAE or DIN correction, at any altitude and air temperature, and keeps runs to compare. Diagnosis gives you a customer complaint and a budget of workshop time to find the fault with era-correct tests. Learn explains each idea in plain words or with the equations, and has challenges. A build can be shared as a link.
Common questions
Is the power figure real or just a lookup?
It is computed. Each operating point comes from a crank-angle simulation of one cylinder over the full 720° cycle: piston kinematics, gas flow through the valves with the real cam timing, pressure waves in the intake runners, combustion with heat release and heat loss to the walls, and a knock model that depends on the fuel octane. A faster model built from those results runs the engine in real time, with friction, inertia, turbo dynamics and the ECU. Each engine was then calibrated against its published torque and power; the remaining differences are listed in Learn → Model and data.
Are these the real engines?
They are generic engines inspired by well-known ones (a Japanese twin-turbo straight-six, an Argentine carburetted six, an American pushrod V8, a European 2.0 turbo four, the Argentine overhead-cam six and a Japanese high-revving four). Bore, stroke, compression, valve sizes, cam timing and ratings come from published data where it exists; what was not published is estimated and marked as such. No brand names or logos are used.
Can I use it to tune my car?
No. It is a teaching simulator: it shows why things happen and in which direction a change pushes the engine, but its maps and limits are not those of any real ECU or part, and a real engine can be damaged by settings that look safe here. Real tuning needs a real dyno, a wideband sensor, knock monitoring and someone with experience.
Why does it take a moment when I change something?
Changing the hardware (a cam, the compression, the turbo, the fuel) means re-running the cycle simulation over a grid of speeds and loads. That runs in a background thread so the page stays responsive; it usually takes one or two seconds, and the result is cached for the session.